My 2018 ND2 2.0 has had the instrument panel replaced under warranty.

The panel has the Rev Uounter in the middle and it is printed dial with a moving pointer
The Speedometer is on the right and is a printed panel with a moving pinter.

On the left is the fuel and temperature guage with a menu of...

I am new to owning a Mk4 and also LED lights . The coming summer we are driving to my Sister's in France and because of LED's wondered if deflectors were needed or of a different type to one I've always used. i Googled the question and one site the answers varied from no because they are a flat...

The following is a guide to topping up the rust proofing of a new or nearly new Mazda MX5 MK4 that has not spent a winter in the UK. This work was done by members of the MX5 Owners Club (Grampian) in the North East of Scotland and includes lesson learned after doing two cars in October 2015.

Mazda...

This afternoon we had a Mk4 on the lift to look at the possible need for topping up the factory underseal.

First thoughts are there are a good few areas that need a further application of Goo.

Behind rear bumper

and again behind the rear bumper

The rear bulkhead

other side

Beside...

To change the oil on a Mk4 you have to remove a metal cover with about 9 off 12mm AF bolts and 2 off 10mm AF bolts. You loose the will to live half way through removing the bolts.

The two rear bolt holes have to be slipped above the rear black plastic cover.

We got it wrong when we replaced it as...

I found that it was better to slide the smaller cross section arm out of the outer arms to lift the MK4 as the flange on the car is quite a bit inboard of the outside of the car and if the inner arm is still completly inside the outer arms the height of the outer arms catches on the plastic sill...