This is a placeholder for a how to on making dials - the DIY way.

I have been asked a lot of times how to do this and I am more than happy to share and help where I can. The 'How To' will be split into three parts:

1. Design
2. Making them and cutting them
3. Fitting them

Being a stickler for...

Some do come with instructions to strip the wire back and remove fuses, shove the wire in the fuse box and push the fuse back in place, PLEASE throw them in the bin, I personally don't and have never liked this unsafe method of doing this, do it once and do it right first time safe and right.
This...

I have fitted these to my own (and owners roadsters) for many years for a number of reasons and it all began and came around for me with a journey home down the M62 from Warrington to Manchester one summer evening in my MK 1 VS II Eunos , on passing the Birchwood junction on slip road and my...

image.jpg Hi all, couldnt find any smoked reflectors so taking Waynes advice did them myself. Very easy to do, and they must be as I got a great end result. May have to be in 2 posts to accomadate the pic's. So firstly, you need the above/below. Plastic primer spray, smoked tint spray, philips...

Inspired by M-m's video on Youtube, I took the plunge and got a set.

Step 1:
Purchase a kit. eBay is littered with these things and the kit I picked up was this one .

Step 2:
Remove the bolts in the locations in green below. The one on the wings/fenders are 10mm (easier to use a deep socket...

If you like stripes, here are some photo's of mine being applied.
If you don't like stripes, here are some photo's of mine being applied.

A few tips-
measure and measure again. Then stand back and make sure your measurements are correct.
Use masking tape to help line up your stripe. Stand back and...

So there I am, at home, bad back - need to do some fettling, but daren't get under the car in case I can't get out. Think hamster, think...

Ah-ha... let's get creative and spend no money in the process. Time for a sitty down job.

Take one centre console - bit tatty, one tombstone that has been...

This is My Guide to fitting a TR Lane roll bar. I posted it to help people out so perfect for on here i think.
Hope the link works :-D

I have been doing this for years, why pay for cheap tacky pedal covers when you can have luxury s/steel Merc pedal covers on your Mx/Roadster
There are a couple of different sets that will fit with a bit of Know how, they will fit all models including Autos and manuals, depending on what you need...